Ford 2012 Transit Connect User Manual download pdf (Page 161)

3. Cycle the ignition to the on

position with the engine off.

4. Turn the hazard flashers on then

off three times. This must be

accomplished within 10 seconds.

If the reset mode has been entered successfully, the horn will sound

once and the TPMS indicator

will flash. If this does not occur, please

try again starting at step 2.

If after repeated attempts to enter the reset mode, the horn does not

sound and the TPMS indicator

does not flash, seek service from your

authorized dealer.

5. Train the TPMS sensors in the tires using the following TPMS reset

sequence starting with the left front tire in the following clockwise

order:

• Left front (Driver’s side front tire)

• Right front (Passenger’s side front tire)

• Right rear (Passenger’s side rear tire)

• Left rear (Driver’s side rear tire)

6. Remove the valve cap from the valve stem on the left front tire;

decrease the air pressure until the horn sounds.

Note: The single horn chirp confirms that the sensor identification code

has been learned by the module for this position. If a double horn is

heard, the reset procedure was unsuccessful, and must be repeated.

7. Remove the valve cap from the valve stem on the right front tire;

decrease the air pressure until the horn sounds.

8. Remove the valve cap from the valve stem on the right rear tire;

decrease the air pressure until the horn sounds.

Tires, Wheels and Loading

161

2012 Transit Connect (tst)

Owners Guide, 1st Printing

USA (fus)

PAGE POSITION: 161 JOB: @zeta.tweddle.com/ford_pdm/ford/own2002/835536-en-tst/og pubnum:

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 298 299

No comments

Ford 2012 Transit Connect User Manual Page 161