Ford W0029 User Manual download pdf (Page 13)

T6991a-0920

• If the clip is upside down or not through both holes in

the axle, you have not assembled it properly. Please

remove the clip and go back to step 18.

CORRECT

INCORRECT

ASSEMBLY

• Insert the "T" fastener end of a short seat belt strap

down through the slot near the outer edge of the

seat. Make sure the fastener side of the seat belt

faces inward.

Note: You will pull only one T-Loop through the slot.

• Repeat this procedure to assemble the other short seat

belt strap.

• Insert each fastener end of the long seat belt strap up

through the slots in the center of the seat. Make sure

the fasteners face the outer edge of the seat.

• Pull each side of the long seat belt strap evenly

through the slots. Make sure to pull each T-loop

through a slot.

Short Seat Belts

Long Seat Belt

• Align the tabs on a hubcap with the slots in a rear

wheel. “Snap” a hubcap into the center of the

rear wheel.

Hint: If the hubcap does not "snap" into place, you may

not have assembled the wire clip properly. Remove the

wire clip and refer back to step 18.

• Repeat steps 17 - 21 to assemble the other rear wheel,

wire clip and hubcap.

Hubcap

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Ford W0029 User Manual Page 13