Ford 2007 Crown Victoria v.3 User Manual download pdf (Page 200)

To lessen risk of personal

injury, do not put any part

of your body under the vehicle

while changing a tire. Do not start

the engine when your vehicle is

on the jack. The jack is ONLY

meant for changing the tire.

• Never use the rear differential

as a jacking point.

8. Remove the metal lug nuts with the lug wrench.

9. Replace the flat tire/wheel assembly with the spare tire/wheel

assembly, making sure the valve stem is facing outward. Reinstall lug

nuts until the wheel is snug against the hub. Do not fully tighten the lug

nuts until the wheel has been lowered.

10. Lower the vehicle by turning the jack handle counterclockwise.

11. Remove the jack and fully

tighten the lug nuts in the order

shown. Refer to Wheel lug nut

torque specifications later in this

chapter for the proper lug nut

torque specification.

12. For full size spare aluminum

wheel, firmly install the center

ornament. If equipped with a full

size spare tire/wheel assembly and

lug nut retained full wheelcover, install the wheelcover by tightening the

five black plastic nuts in the order shown on the wheelcover using the

lug wrench with about 80 lb. in. (9 N•m) torque. Then firmly install the

wheelcover center ornament.

13. Put flat tire, jack and lug wrench away.

14. Turn on the air suspension switch (if equipped).

WHEEL LUG NUT TORQUE SPECIFICATIONS

Retighten the lug nuts to the specified torque within 100 miles (160 km)

after any wheel disturbance (tire rotation, changing a flat tire, wheel

removal, etc.).

2007 Crown Victoria (cro)

Owners Guide (post-2002-fmt)

USA (fus)

Roadside Emergencies

200

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 271 272

No comments

Ford 2007 Crown Victoria v.3 User Manual Page 200