Ford 2004 Mustang v.2 User Manual download pdf (Page 81)

• Followed by three seconds with the safety belt

warning light off.

• Once again, the safety belt warning light will flash

four times per second for three seconds.

9. After receiving confirmation, the

deactivation/activation procedure is complete.

Safety belt extension assembly

If the safety belt is too short when fully extended,

there is a 20 cm (8 inch) safety belt extension

assembly that can be added (part number 611C22).

This assembly can be obtained from your dealer at

no cost.

Use only extensions manufactured by the same

supplier as the safety belt. Manufacturer

identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if

the safety belt is too short for you when fully

extended.

Do not use extensions to change the fit of

the shoulder belt across the torso.

Safety belt maintenance

Inspect the safety belt systems periodically to make

sure they work properly and are not damaged.

Inspect the safety belts to make sure there are no

nicks, tears or cuts. Replace if necessary. All safety

belt assemblies, including retractors, buckles, front

seat belt buckle assemblies, buckle support

assemblies (slide bar-if equipped), shoulder belt

height adjusters (if equipped), shoulder belt guide

on seatback (if equipped), child safety seat LATCH

and tether anchors, and attaching hardware, should

be inspected after a collision. Ford Motor Company

recommends that all safety belt assemblies in use in

vehicles involved in a collision be replaced. However,

if the collision was minor and a qualified technician

finds that the belts do not show damage and

continue to operate properly, they do not need to be

2004 Mustang (mus)

Owners Guide (post-2002-fmt)

USA English (fus)

Seating and Safety Restraints

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 136 137

No comments

Ford 2004 Mustang v.2 User Manual Page 81