Ford 2004 Freestar v.3 User Manual download pdf (Page 144)

4. Within 10 seconds of the light turning on, buckle then unbuckle the

safety belt.

• This will disable the BeltMinder feature for that seating position if it is

currently enabled. As confirmation, the restraint system warning light

will flash 4 times per second for 3 seconds.

• This will enable the BeltMinder feature for that seating position if it is

currently disabled. As confirmation, the restraint system warning light

will flash 4 times per second for 3 seconds, followed by 3 seconds with

the light off, then followed by the restraint system warning light

flashing 4 times per second for 3 seconds again.

Safety belt extension assembly

If the safety belt is too short when fully extended, a 23 cm (9 inch) or

31 cm (12 inch) safety belt extension assembly can be added (part

numbers 611C22–A and 611C22–B respectively). These assemblies can

be obtained from your dealer at no cost.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

Do not use extensions to change the fit of the shoulder belt

across the torso.

Safety belt maintenance

Inspect the safety belt systems periodically to make sure they work

properly and are not damaged. Inspect the safety belts to make sure

there are no nicks, tears or cuts, replacing if necessary. All safety belt

assemblies, including retractors, buckles, front seat belt buckle

assemblies, buckle support assemblies (slide bar-if equipped), shoulder

belt height adjusters (if equipped), child safety seat tether bracket

assemblies (if equipped), LATCH child seat tether anchors and lower

anchors (if equipped), and attaching hardware, should be inspected after

a collision. Ford recommends that all safety belt assemblies in use in

vehicles involved in a collision be replaced. However, if the collision was

minor and a qualified technician finds that the belts do not show damage

and continue to operate properly, they do not need to be replaced,

except as described in the Replacing the front seat belt assemblies

after a collision section of this chapter. Safety belt assemblies not in use

during a collision should also be inspected and replaced if either damage

or improper operation is noted.

2004 Freestar (win)

Owners Guide (post-2002-fmt)

USA English (fus)

Seating and Safety Restraints

144

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 295 296

Comments to this Manuals

No comments

Ford 2004 Freestar v.3 User Manual Page 144

Comments to this Manuals

Related products and manuals for Cars Ford 2004 Freestar v.3