Ford 2004 Freestar v.3 User Manual Page 267

  • Download
  • Add to my manuals
  • Print
  • Page
    / 296
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 266
10. Tire Ply Composition and Material Used: Indicates the number of
plies or the number of layers of rubber-coated fabric in the tire tread and
sidewall. Tire manufacturers also must indicate the ply materials in the
tire and the sidewall, which include steel, nylon, polyester, and others.
11. Maximum Load: Indicates the maximum load in kilograms and
pounds that can be carried by the tire. Refer to the tire label or the
safety certification label, located on the B-Pillar or the drivers door, for
the correct tire pressure for your vehicle
12. Treadwear, Traction and Temperature Grades
Treadwear: The treadwear grade is a comparative rating based on the
wear rate of the tire when tested under controlled conditions on a
specified government test course. For example, a tire graded 150
would wear one and one-half (1
1
2
) times as well on the government
course as a tire graded 100.
Traction: The traction grades, from highest to lowest are AA, A, B,
and C. The grades represent the tires ability to stop on wet pavement
as measured under controlled conditions on specified government test
surfaces of asphalt and concrete. A tire marked C may have poor
traction performance.
Temperature: The temperature grades are A (the highest), B and C,
representing the tires resistance to the generation of heat and its
ability to dissipate heat when tested under controlled conditions on a
specified indoor laboratory test wheel.
13. Maximum Permissible Inflation Pressure: Tire manufactures
maximum permissible pressure and/or the pressure at which the
maximum load can be carried by the tire. This pressure is normally
higher than the manufacturers recommended cold inflation pressure
which can be found on either the tire label or certification label which is
located on the structure by the trailing edge of the drivers door or the
edge of the drivers door. The cold inflation pressure should never be set
lower than the recommended pressure on the vehicle label.
The tire suppliers may have additional markings, notes or warnings such
as standard load, radial tubeless, etc.
2004 Freestar (win)
Owners Guide (post-2002-fmt)
USA English (fus)
Maintenance and Specifications
267
Page view 266
1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 295 296

Comments to this Manuals

No comments