Ford 2004 Freestar v.3 User Manual download pdf (Page 212)

4. Check that the flat tire is properly secured.

Stowing the spare tire

Note: If no tire is to be stowed under the vehicle, attach the secondary

(locking) wheel retainer to the primary retainer using cable tie provided.

Make sure to pass the tie through

one of the “loops” on the secondary

(locking) retainer,

then around the primary cable. This

allows the secondary (locking)

retainer to be raised. Do not allow

either retainer to contact ground

while driving.

1. Lay the spare, inflated tire on the ground with the valve stem facing in

the direction specified on the Tire Changing Instructions located with the

jack hardware.

2. Slide the wheel partially under the vehicle and install the secondary

(locking) retainer through an outer hole in the tire, and rotate

one-quarter turn to locked position. Install the primary retainer through

the center of the tire. Pull on the cable to align the components at the

end of the cable.

3. Wagon only: Raise the tire by turning the lug nut wrench clockwise

until the hex nut ratchets.

Cargo van only: Raise the tire by turning the jack extension tool

clockwise with the lug nut wrench until the hex nut ratchets.

2004 Freestar (win)

Owners Guide (post-2002-fmt)

USA English (fus)

Roadside Emergencies

212

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 295 296

No comments

Ford 2004 Freestar v.3 User Manual Page 212