Ford 2004 Freestar v.3 User Manual download pdf (Page 62)

Resetting the PSD

The power sliding door may operate incorrectly or not at all because of

the following conditions:

• a low voltage or dead battery

• the door is left opened for more than 6 hours

• the battery is disconnected

• the PSD Passenger compartment fuse panel fuse (fuse #11) is

removed or blown. Refer to Fuses and relays in the Roadside

Emergencies chapter.

If any of the above conditions has occurred, perform the following steps

to reset the PSD so that electronics can relearn the open and closed

positions:

1. Check to see if PSD is securely closed.

2. Make sure the gearshift is in (P) Park.

3. Push the PSD control on the overhead console to open the door.

4. Wait five (5) seconds and close the door by pressing the PSD control

on the overhead console.

5. Wait five (5) seconds and repeat Steps 3 and 4 then go on to step 6.

6. Repeat steps 3–5 for opposite door.

If the door still does not operate correctly:

7. Ensure the ignition is in the OFF position

8. Remove the PSD fuse (fuse #11) from the passenger fuse panel and

leave it out for thirty (30) seconds. Refer to the chapter on Fuses and

Relays. Refer to Fuses and relays in the Roadside emergencies

chapter.

9. Reinstall the fuse and wait ten (10) seconds.

10. Repeat steps 1–6 above.

If the door still does not operate correctly, see your dealer for service.

Sliding Door Child Safety Lock

Your vehicle is equipped with a sliding door child safety lock that helps

prevent passengers from operating the sliding door by using the inside

door handle, refer to the Child safety locks section in this chapter.

2004 Freestar (win)

Owners Guide (post-2002-fmt)

USA English (fus)

Driver Controls

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 295 296

No comments

Ford 2004 Freestar v.3 User Manual Page 62