Ford 2009 Flex v.1 User Manual download pdf (Page 156)

Memory seat/power mirrors/adjustable pedals (if equipped)

This system allows automatic

positioning of the driver seat,

outside rearview mirrors and

adjustable pedals to two

programmable positions.

The memory seat control is located

on the driver door.

• To program position one, move the driver seat, exterior mirrors and

adjustable pedals to the desired positions using the associated

controls. Press and hold control button 1 for at least two seconds.

• To program position two, repeat the previous procedure using control

button 2.

• A tone will be heard when the memory save is complete.

A position can only be recalled when the transmission gearshift is in Park

(automatic transmission). A memory seat position may be programmed

at any time.

The memory seat positions are also recalled when you press your remote

entry transmitter

(unlock) control and the transmitter is

programmed to a memory seat position or when you enter a valid

customer code 1 or 2 on the keypad.

To program the memory seat to remote entry transmitter, refer to

Remote entry system in the Locks and Security chapter..

Note: The seat will not travel to its final position if the key is not

in the ignition and the easy entry feature is enabled.

Easy-entry/easy-exit feature (if equipped)

This feature automatically moves the driver’s seat rearward 2 in (5 cm)

when:

• the transmission is in N (Neutral) or P (Park)

• the key is removed from the ignition

The seat will move to the original position when:

• the transmission is in N (Neutral) or P (Park)

• the key is placed in the ignition.

The easy entry feature can be turned off or on through the vehicle

message center. Refer to Message center in the Driver controls chapter.

2009 Flex (471)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

156

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 373 374

No comments

Ford 2009 Flex v.1 User Manual Page 156