Ford 2009 Flex v.1 User Manual download pdf (Page 96)

WARNING: Do not keep electrical devices plugged in the power

point whenever the device is not in use. Do not use any

extension cord with the 110 VAC power point, since it will defeat the

safety protection design provided by the cap and twist tab. Doing so

my cause the power point to overload due to powering multiple

devices that can reach beyond the 150W load limit and could result in

fire or serious injury.

The power point can switch to a fault mode when it is overloaded,

overheated, or shorted. For overloading and shorting conditions, unplug

your device and turn the ignition key off then on. For an overheating

condition, let the system cool off, then turn the ignition key off then on.

The 110 VAC power point can provide power whenever the vehicle

ignition is in the run position and the power point green indicator light

located in the top left corner is turned on. Refer to the indicator light

code below for the power point status.

Indicator light Code

Green light is On — Power point is ready to supply power

Green light is Off — Power point power supply is off. Ignition is not in

RUN position

Green light is blinking — Power point is in fault mode

POWER WINDOWS

WARNING: Do not leave children unattended in the vehicle and

do not let children play with the power windows. They may

seriously injure themselves.

WARNING: When closing the power windows, you should verify

they are free of obstructions and ensure that children and/or

pets are not in the proximity of the window openings.

2009 Flex (471)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 373 374

No comments

Ford 2009 Flex v.1 User Manual Page 96