Ford 2011 E-450 v.2 User Manual download pdf (Page 26)

Note: If the SELECT/RESET stem is pressed during the calibration or

three minutes has elapsed since the beginning of the calibration without

driving the vehicle, the message center reverts back to normal operation

and the CAL will display until a successful calibration is carried out.

5. Slowly drive the vehicle in a circle less than 3 mph (5 km/h ) until the

CIRCLE SLOWLY TO CALIBRATE message changes to CALIBRATION

COMPLETED.

LANGUAGE = ENGLISH / SPANISH / FRENCH

Allows you to choose which language the message center will display in.

Selectable languages are English, Spanish, or French.

Waiting four seconds or pressing the RESET button cycles the message

center through each of the language choices.

Press the RESET button to set the language choice when the language

you want appears.

Press the SELECT/RESET stem for the next setup menu item or wait for

more than four seconds to return to the info menu.

HOLD RESET FOR SYSTEM CHECK

Press and hold the SELECT/RESET stem to select system check when

HOLD RESET FOR SYSTEM CHECK is displayed in the message center.

For each of the monitored systems, the message center will indicate

either an ok message or a warning message for two seconds. Pressing the

SELECT/RESET stem cycles the message center through each of the

systems being monitored.

The sequence of the system check report and how it appears in the

message center is as follows:

1. XXX% OIL LIFE (Gas engine only)

2. ENGINE HOURS

3. ENGINE IDLE HOURS

4. CHARGING SYSTEM

5. BRAKE SYSTEM

6. TBC GAIN = XX.X

NO TRAILER (if equipped and no trailer connected)

7. TBC GAIN = XX.X

OUTPUT = ////// (if equipped and trailer connected)

8. XX MILES TO E FUEL LEVEL XXX

System warnings

System warnings alert you to possible problems or malfunctions in your

vehicle’s operating systems.

Instrument Cluster

2011 Econoline (eco)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 333 334

No comments

Ford 2011 E-450 v.2 User Manual Page 26