Ford 1999 Windstar User Manual download pdf (Page 91)

POSITIVE RETENTION FLOOR MAT (IF EQUIPPED)

To install floor mats that have a retention post:

Position the floor mat so that the

eyelet is over the pointed end of the

retention post and rotate forward to

lock in. Make sure that the mat does

not interfere with the operation of

the accelerator or the brake pedal.

To remove the floor mat, reverse the

installation procedure.

To install floor mats that have a screw in retainer:

1. Move the driver’s seat to the most rearward position

2. Position the driver’s side floor mat with the rear of the mat against left

(outboard) front edge of seat track mounting bracket.

3. Use a screwdriver to screw locator post into vehicle carpeting. Exert

pressure while turning to pierce the carpeting.

When installed properly, the locator will not screw down tightly, but will

rotate freely.

Use only Ford original Equipment floor mats. Do not stack multiple floor

mats over the Ford original equipment floor mats as they are not

positively retained.

REMOTE ENTRY SYSTEM

The remote entry system allows you to:

• lock or unlock all vehicle doors and liftgate without a key.

• unlock/open a RH power sliding door and/or LH power sliding door (if

equipped).

• activate the personal alarm.

• arm and disarm the perimeter anti-theft system (if equipped).

The lock/unlock and power sliding door features will operate with the

vehicle in P (Park) or N (Neutral) and the ignition in the OFF, ACC or

RUN positions. The panic control feature only operates with the ignition

in the OFF position.

Controls and features

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 247 248

No comments

Ford 1999 Windstar User Manual Page 91