Ford 2014 Escape v.4 User Manual download pdf (Page 261)

WARNINGS

If your vehicle slips off the jack, you

or someone else could be seriously

injured.

Do not attempt to change a tire on

the side of the vehicle close to

moving traffic. Pull far enough off the

road to avoid the danger of being hit when

operating the jack or changing the wheel.

To lessen the risk of personal injury,

do not put any part of your body

under your vehicle while changing a

tire. Do not start the engine when your

vehicle is on the jack. The jack is only

meant for changing the tire.

Note: Passengers should not remain in your

vehicle when the vehicle is being jacked.

1. Park on a level surface, set the parking

brake and activate the hazard flashers.

2. Place the transmission in park (P) and

turn the engine off.

3. Remove the carpeted wheel cover.

4. Remove the wing nut that secures the

spare tire by turning it

counterclockwise.

E160855

5. Remove the jack from the foam holder.

The lug wrench is located in the left

side storage foam next to the spare

tire. Remove the flat tire retainer strap

from the jack base.

E142551

6. Block the diagonally opposite wheel.

7. Loosen each wheel lug nut one-half

turn counterclockwise, but do not

remove them until the wheel is raised

off the ground.

Note: Jack at the specified locations to

avoid damage to the vehicle.

8. The vehicle jacking points are shown

here, and are depicted on the yellow

warning label on the jack.

E145908

9. Small arrow-shaped marks on the sills

show the location of the jacking points.

E162190

258

Escape (TM2) , enUSA

Wheels and Tires

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 433 434

Comments to this Manuals

No comments