Ford 1999 Windstar User Manual download pdf (Page 83)

To program your hand-held

transmitters:

• continue to hold the button on

the HomeLinkt Universal

Transceiver.

• press and re-press the hand-held

transmitter button every two

seconds until the red light changes from a slow to a fast flash.

Operating the HomeLinkT Universal Transceiver

Once programmed, the HomeLinkt

Universal Transceiver can be used in

place of hand-held transmitters. To

operate, simply press and release

the appropriate HomeLinkt button

(the red light will illuminate,

indicating the signal is being

transmitted).

Rolling code programming

Rolling code garage door openers (or other rolling code devices) which

are “code protected” and manufactured after 1996, may be determined

by the following:

• Reference the device owner’s manual for verification

• The hand-held transmitter appears to program the HomeLinkt

Universal Transceiver but does not activate the device.

• Press and hold the trained HomeLinkt button. The device has the

rolling code feature if the indicator light flashes rapidly and then turns

solid after 2 seconds.

After completing the “Programming” functions, follow these steps to

train a garage door opener with the rolling code feature:

1. Locate the training button on the garage door motor head unit.

Refer to the garage door opener manual or call 1–800–355–3515 or on

the Internet at HomeLink.jci.com. if there is difficulty locating the

training button.

2. Press the training button on the garage door motor head unit (which

will activate the “training” light.)

Controls and features

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 247 248

No comments

Ford 1999 Windstar User Manual Page 83