Ford 2015 Fusion User Manual download pdf (Page 230)

Jump Starting

1. Start the engine of the booster vehicle

and rev the engine moderately, or press

the accelerator gently to keep your

engine speed between 2000 and 3000

rpms, as shown in your tachometer.

2. Start the engine of the disabled vehicle.

3. Once the disabled vehicle has been

started, run both vehicle engines for an

additional three minutes before

disconnecting the jumper cables.

Removing the Jumper Cables

Remove the jumper cables in the reverse

order that they were connected.

4

1

3

2

E142665

1. Remove the jumper cable from the

ground metal surface or connecting

point, if available.

2. Remove the jumper cable on the

negative (-) terminal of the booster

vehicle's battery.

3. Remove the jumper cable from the

positive (+) terminal of the booster

vehicle's battery.

4. Remove the jumper cable from the

positive (+) terminal of the disabled

vehicle's battery.

After the disabled vehicle has been started

and the jumper cables removed, allow it

to idle for several minutes so the battery

can recharge.

POST-CRASH ALERT SYSTEM

The system flashes the turn signal lamps

and sounds the horn (intermittently) in the

event of a serious impact that deploys an

airbag (front, side, side curtain or Safety

Canopy) or the safety belt pretensioners.

The horn and lamps will turn off when:

• The hazard control button is pressed

• The panic button (if equipped) is

pressed on the remote entry

transmitter

• Your vehicle runs out of power

SPINOUT DETECTION

If your vehicle detects a spinout and it

comes to a stop, the hazard warning

flashers turn on. A spinout detected

message appears in the information

display. The message may not appear if

your vehicle runs out of power.

After your vehicle's hazard warning

flashers turn on, you can switch them off

by:

• Pressing the hazard warning flasher

button.

• Pressing the remote control unlock

button.

227

Fusion/Mondeo (CC7), enUSA

Roadside Emergencies

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 487 488

Comments to this Manuals

No comments