Ford 2008 E-450 v.3 User Manual download pdf (Page 139)

TPMS reset tool

A special TPMS reset tool to reset your TPMS after tire rotation is

provided with vehicles that have different front and rear tire pressures.

The tool is located with your Owner’s Guide materials.

Please take the tool with the

provided Velcro威 strip on the back

and mount it in the bottom right

corner of your Owner’s Guide case

(as shown) for safe keeping.

If you find that the reset tool was

not provided when delivered, has

been lost or no longer functions

(the battery is not replaceable),

please contact your authorized

dealer to obtain a replacement.

To verify that your TPMS reset tool is working, press and release the

button on the center of the TPMS tool. The red light should illuminate

and remain on for approximately five (5) seconds. If the light does not

illuminate, the tool needs to be replaced.

TPMS reset tips

To reduce the chances of interference from another vehicle, TPMS reset

should be performed at least three feet (one meter) away from another

Ford Motor Company vehicle undergoing the TPMS reset procedure at

the same time.

Do not wait more than two (2) minutes between resetting each tire

sensor or the system will timeout and the entire procedure will have to

be repeated on all four wheels.

A double horn chirp indicates the need to repeat the procedure.

TPMS reset procedure

Note: It is recommended that you read the entire procedure before

attempting.

Note: To enter the reset mode, Steps 1–5 MUST be completed within

60 seconds.

1. The key must be in the ignition and the ignition turned to OFF/LOCK.

Press and release the brake pedal.

2. Cycle the ignition from OFF/LOCK to RUN three (3) times ending in

the RUN position. DO NOT start the engine.

2008 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Tires, Wheels and Loading

139

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 284 285

No comments

Ford 2008 E-450 v.3 User Manual Page 139